Aqua Medic T Controller Twin
Microprocessor controlled digital temperature monitor and controller for heating and cooling in freshwater or seawater aquariums.
When a heater or chiller fails it is generally catastrophic to an aquarium if it is not found at the early stages. Too cold or too hot can decimate an aquarium but to have a fall back system is imperative and this is where the Aqua Medic T Controller is a must-have.
Please note this unit comes with Australian plug and sockets, complying with Australian Law.
T Controller Twin
Please keep in mind that although you can have a maximum of 1200w heating and 400w cooling - the total capacity combined can not exceed 1200w.
-
The maximum load for the heating and cooling systems is 1,200 watts.
-
Easy to read digital temperature display also indicates heating and cooling mode.
-
Includes battery back up so settings are saved if power fails.
-
Socket 2 - Control heaters up to 1,200watt.
-
Socket 1 - Control fans or cooling units up to 400 watts.
-
Measurement range: 16 to 40 deg. C in 1 deg. C increments with accuracy of 0.1 degrees C.
-
Accuracy is 0.1 ° C
Main Information:
Temperature monitor and controller heat controller duo used to control aquarium heaters.
Measurement and switching accuracy is 0.1 ° C. The set point can be in 0.1 ° C increments in the range the 0 - 50 ° C can be adjusted and is regulated at 1 ° C.
Maximum total switching capacity for heater and floor heating is 1,200 watts.
Integrated double outlet in each case a heating element and a ground heater can be connected simultaneously.
Heat controller duo is equipped with a temperature sensor permanently connected.
LCD display is at any time about the current temperature, the time and the switching state of the connected devices.
Heating cable is clocked by a timer, the clock rate can be freely selected. If the desired setpoint is not reached, the rod heater switched on.
To avoid overheating, both heaters are switched off as soon as the setpoint is exceeded by a settable value.
